How to prime the Kangertech OCC Coil
Priming the coil – There is 2 holes either side of the coil which you can see the cotton which is inside the coil, drip some e-liquid in each hole and some down the middle through the top then once you have soaked some liquid into the coil just blow down the hole at the top to remove any remaining liquid. Once that is done, screw the coil into the base and then put into your tank which is full of the same liquid you primed the coil with, and then allow the coil to soak up more liquid for 20-30 minutes to ensure it has had a real good soak in liquid.
Leaving it to soak in liquid – Another way to prime your coil is to either leave a spare coil in a little small tub of your liquid to soak and when needed just blow through the hole at the top and place into your tank which is full of liquid or another way is to top up your tank with liquid and leave your coil in the tank before you go bed then when you awaken in the morning the coil would of had a proper soak in the liquid.
Using VG and Wattage Guide
This VG and Wattage Guide will help you to ensure your coils last a very long time and not burn out too quickly, with knowing your measurements of VG you will be able to identify what Watts you can go up to, using this guide it very helpful so be sure to show this to your friends who also vape.
0.5 ohm coil:
80-100% VG – 15-40 Watts Max
50-70% VG – 15-50 Watts Max
20-40% VG – 15-60 Watts Max
1.2 ohm coil:
80-100% VG – 10-18 Watts Max
50-70% VG – 10-22 Watts Max
20-40% VG – 10-26 Watts Max
For £3.00 these coils should last 3-4 weeks if primed right.